Configuring Microham Usb Device Router - microHAM MK2R Manual

The microHAM USB Device Router (Router) program provides a Windows compatible configuration tool for
microHAM USB Devices (MK2R or MK2R+ as well as DIGI KEYER, microKEYER, CW Keyer and USB
Interfaces) and software interface to other Windows applications (logging software, digital mode software,
etc.). The software interface is provided as Virtual Serial Ports.
In order to configure and use MK2R with Windows compatible application programs, you must have
installed the USB driver, started Router, applied power to MK2R and turned the device on. Router is then
configured as required by the application (logging, control or digital mode) software.
MK2R includes an LPT (parallel) input. This connection is required for applications which do not support
the microHAM SO2R Control Protocol or provide focus control information on a serial port.
Router must be used to configure MK2R for proper operation. The device configuration tabs (in the red
rectangle) are used to setup each part of the MK2R.
microHAM © 2010 All rights reserved

Configuring microHAM USB Device Router

MK2R Status
When the USB driver is installed correctly and MK2R is turned
on Router will show a device tab with a GREEN check beside
the device name (micro KEYER 2R).
When Router shows a YELLOW "X" instead of a green
means the USB driver is correctly installed but MK2R is not
turned on.
When Router shows a RED "X" instead of a green
the device is disconnected and Router does not see the USB
part of MK2R. This happens when the USB cable is unplugged
or the USB driver is not correctly installed.
Initial Setup
19
, it
, it means