microHAM MK2R Manual page 68

14. On the DVK tab, select default bank, set the REC MIC, TX MASTER and TX WAVE levels to the same
position as you set on the Audio Mixer tab.
15. Press the "Record" button and adjust the recording level with the REC MIC level so that signal does not
peak into to the red area.
16. Select Radio 1
17. Press the "Play" button and check that the drive level to Radio 1 is same as you set in the previous steps.
If not, adjust the R1 WAVE level.
18. Select Radio 2
19. Press the "Play" button and check that the drive level to Radio 2 is same as you set in the previous steps.
If not, adjust the R2 WAVE level.
NOTE: Slider positions in the DVK tab are independent of those in the Audio Mixer tab. They are stored
with the message banks, not with presets. This permits each operator to customize the DVK for his own
voice.
20. The voice settings are now complete.
21. Select an AFSK mode on RADIO1 and RADIO2. (PKT, DIG or DATA for Yaesu, LSB-D or USB-D for
current Icom transceivers, RTTY or RTTY-R on K2, and USB or LSB for Kenwood, TenTec and old Icom
transceivers). Do not select RTTY or FSK; those modes do not use the audio input.
22. Go to Router's Audio Switching tab and set FSK/DIGITAL to "BBB, audio codec SC2" for each radio.
Make sure the FSK/DIGITAL switching has a black (not gray) frame around it on each radio tab.
23. Select the PTT tab, set FSK/DIGITAL to "PTT2 (rear panel jack)" for each radio.
24. Switch to the Audio Mixer tab and set TX DIGITAL MASTER and WAVE levels to 70%.
25. Select Radio 1.
26. Confirm that all transceiver signal processing circuits (speech processor, TX DSP, etc.) are off.
27. Press the "Test Signal" button and adjust the R1 Wave slider for normal drive level - rated power output
with the lowest possible ALC reading. Do Not adjust the radio Mic Gain, the TX1 control or the Radio 1
trimmer.
NOTE: For the Elecraft K3 only: Do not adjust the R1 Master/Wave sliders. Instead, adjust the Line In
level (Mic Gain) until the ALC shows five (5) bars.
28. Select Radio 2.
29. Press the "Test Signal" button and adjust the R2 Wave slider for normal drive level - rated power output
with the lowest possible ALC reading. Do Not adjust the radio Mic Gain, the TX1 control or the Radio 1
trimmer.
30. This will have set proper levels for both radios and all modes. We suggest that you to store these Router
settings to the last preset. Click Preset | Save as, choose position number 12, name it Default and store
settings.
TIP: When you create your presets, always begin by selecting the "default" preset. This will set
audio levels to a known state before starting any customization.
microHAM © 2010 All rights reserved
68