For The Condenser - Blomberg TKF 8439 User Manual

Water tank may be located in two different
places as indicated below, depending
on the model of your dryer.
- Inside the drawer on the panel
- Behind the kick plate cover
If you forget to drain the water tank, your
dryer will stop during the following
drying cycles when the water tank is
full and the "Water tank" warning light
will turn on. If this is the case, press the
"Start/Pause/Cancel" button to resume
the drying cycle after draining the water
tank.
To drain the water tank:
1. Carefully remove the water tank by
opening the kick plate cover/pulling the
drawer.
2. Drain the water by opening the water
tank cover.
3. If there is lint accumulation in the water
tank cover, clean it and press to close.
4. Place the water tank into its seat.

For the condenser

Hot and humid air in the condenser is
cooled with the cold air from the room.
Thus, the humid air circulating in your
dryer is condensed and then pumped into
the tank.
C Clean the condenser after every 30
drying cycles or once a month.
To clean the condenser:
1. If a drying process has been carried out,
open the door of the machine and wait
until it cools down.
2. Unlock the 2 condenser locks after
opening the kick plate.
3. Pull out the condenser.
4. Clean the condenser by applying
pressurized water with a shower
armature and wait until the water
drains.
5. Place the condenser in its housing.
Fasten the 2 locks and make sure that
they are seated securely.
6. Close the kick plate cover.
20
EN