Hitachi GR2000 Series Configuration Commands page 71

{ in | out }
Inbound/Outbound is designated. Either one or both of the Inbound/Outbound
can be set simultaneously.
in :Inbound (Designation of frame input side)
out:Outbound (Designation of frame output side)
Default:
[-disable]
The flow control is nullified by each input/output interface.
Default:
list <List No.>
The list numbers are designated.
Default:
Range of value:
[list <List No.>-list <list No.>]
Description:
Default:
Range of value:
free
Description:
Default:
min_no
Description:
Default:
Flow detecting condition parameter
{ ip | <protocol No.> | tcp | udp | icmp | igmp }
Description:
Default:
Range of value:
GR2K-GA-0014
Ver. 07-02
No default is possible.
No default is possible.
Default is possible only for the case of indication. All the lists
are indicated at default.
IPv4 filter list: 1 to 20000 (decimal)
Specifies the range of a list number. This parameter can be
specified only when a blank list number is displayed.
The range of the list number to be displayed corresponds to all
list numbers.
IPv4 filter list: 1 to 20000 (Decimal)
IPv6 filter list: 40001 to 60000 (Decimal)
Displays the blank list number.
Cannot be omitted when the blank list number is displayed.
Displays the top blank list number in the specified range.
Cannot be omitted when the top list number of a blank list
number is displayed.
The high-order protocol numbers or protocol names are
designated. If all protocols are taken as the object, IP is
designated.
In case of IPv4 filter list, icmp6 cannot be designated. In case
of IPv6 filter list, icmp and igmp cannot be designated.
No default is possible.
0 to 255 (decimal). (Please refer to Table 1-22.)
Filtering/QoS Information
1-29