Hitachi GR2000 Series Configuration Commands page 426

Hitachi gigabit router configuration guide
Hide thumbs Also See for GR2000 Series:
Table of Contents

Advertisement

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 5-5
import: invalid number of route-filter lists value
at <Value> not in range 1 to 8
import: invalid octet value at <Value> not in
range 0 to 255
import: invalid preference value at <Value>
not in range 2 to 255
import: invalid policy group number value at
<Group Number> not in range 1 to 16
import: invalid range end: <Value>
import: invalid range start: <Value>
import: invalid route-filter number value at
<Value> not in range 1 to 65535
import invalid vpn number value at <Value>
not in range 1 to <Max_Value>
import: IPv6 Interface not found at '<Interface
name>'
import: IPv6 prefix cannot be linklocal in
configuration
import: IPv6 prefix cannot be multicast in
configuration
import: linklocal address should be followed
by %(IPv6 interface name)
import: low end of range (<Value1> bits) is
greater than high end (<Value2> bits)
import: low end of range <Mask1> shorter
than prefix mask <Mask2>
import: mask not contiguous
import: metric option of route-filter must not be
define for {import filter | bgp | bgp4+}
import: Non-masked bits not zero for
<Address> mask <Mask>
5-36
Routing Protocol Error Messages (continued)
Specified route filter count is over the limit. Specify the count up to 8.
<Value>: Specified route filter count
More than 255 values are defined in dot notation. Specify value
within the range of 0 to 255.
<Value>: Specified value
Preference value is invalid. Specify a value within the range of 2 to
255.
<Value>: Specified preference value
Policy group number value is out of valid range. Specify value within
the range of 1 to 16.
<Group Number>: Specified policy group number
In aspath_term{m,n}, m>n or n is more than 256. Set a start value
less than the end value or assign a value less than 255 to the end
value.
<Value>: Specified end value (n)
In aspath_term {m, n}, {m}, {m,}, more than 256 is specified for m.
Use a value less than 255.
<Value>: Specified start value (m)
ID number is out of valid range. Specify value within the range of 1 to
65535.
<Value>: Specified ID number
VPN number is out of valid range. Specify a value within the range of
1 to <Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
The interface of the specified interface name cannot be found.
Specify it by using the defined interface name.
<Interface name>: Specified interface name
The link local address is specified in the network address. Do not use
the link local address.
The multicast address is specified in the network address. Do not
use the multicast address.
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
In the between specification, lower limit of the mask range is greater
than upper limit.Reduce lower limit value of the mask range to less
than upper limit value.
<Value1>: Lower limit of mask range
<Value2>: Upper limit of mask range
In the between specification, lower limit of the mask range is
overlapped with specified mask. Correct the value so the mask range
does not overlap with specified mask.
<Mask1>: Lower limit of specified risk range
<Mask2>: Specified mask
Bit 1 of the specified mask does not continue. Use a mask where bit
1 continues.
The metric option for the route filter is defined in the import filter or
the BGP/BGP4+ protocol. Do not specify the metric option.
At mask, 1 is set to non-masked bit of the specified address. Set
non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
GR2K-GA-0014
Ver. 07-02

Advertisement

Table of Contents
loading

Table of Contents