Filter-List (Filter List Information In The Old Bsd Unix-Based Command System) - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Related Configuration Object
Precautions
1. Use the filter command with the set subcommand must precede that of the
related command shown above. If the filter information is set once, further input
is enabled as long as the filter information is not deleted.
2. When the filter information is defined, applicable parameters of the
object,
3. If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed IP
routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
1.1.11 filter-list (Filter List Information in the Old BSD UNIX-Based Command
System)
Function
Object for creation, modification, deletion, and display of the filter list information.
The filter list determines whether to forward or discard packets that match a specific
condition. Packets not matching such a condition are forwarded. A maximum of
1024 filter list entries (filter conditions) can be created per device.
Input Format
To create or modify the filter list information:
To delete the filter list information:
To show the filter list information:
To show all of the free entry No.:
1-110
object, and
filter-group
object must also be defined.
filter-interface
filter-list
GR2K-GA-0014
Ver. 07-02