Snmp Information; Table 4-2 List Of Initial Value Items That Can Be Set Using Snmp Information And Initial Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4.7.2

SNMP Information

Input Format
d e f a u l t
Parameters
The initial value items that can be set using SNMP information and the initial values
during initial installation are shown in Table 4-2. For details of each parameter, refer
to the configuration definition information in "Section 3.1, "SNMP Objects".
Table 4-2
Information
Information Name
Group Name
SNMP Reference mode of MIB information
information
Trap transmission mode
Transmission level of system message
Trap
Selection of Trap version
Transmission level of system message
Trap during trap selection
Limited moment of coldStart trap issuing
Number of log entries in which RMON
static information is stored
Time interval at which RMON static
information is collected
Timing in which RMON threshold check
starts
Limited moment of link trap issuing
Selection of link trap appended
information
4-34
List of Initial Value Items that Can Be Set Using SNMP Information and Initial
Values during Initial Installation
Initial Value
Only the reference of MIB information is enabled.
(Read)
Not transmitted. (None)
System message Trap for a fatal failure is transmitted.
(Level 9)
Version 1
System message Trap for fatal failure (Level 9)
The moment at which coldStart trap is issued is not
limited. (limited_coldstart_trap)
50 entries
Static information is collected at intervals of 30 minutes.
An alarm is generated when the upward or downward
threshold value is exceeded during first sampling.
(rising&falling)
The moment at which link trap is issued is not limited.
(protocol)
When link traps are issued, it is information that
appends MIBS that comply with RFC (standard)
GR2K-GA-0014
Ver. 07-02