Hitachi GR2000 Series Configuration Commands page 440

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Table 5-5
static: invalid octet value at <Value> not in
range 0 to 255
static: invalid pollcount value at xxx not in
range 1 to 10
static: invalid pollinterval value at <Value> not
in range 5 to 180
static: Invalid pollinterval
static: invalid preference value at <Value> not
in range 2 to 255.
static: invalid vpn number value at <Value>
not in range 1 to <Max_Value>
static: IPv6 prefix cannot be linklocal in
configuration
static: IPv6 prefix cannot be multicast in
configuration
static: IPv6 static interface statement should
be used for non- broadcast I/F
static: linklocal address should be followed by
%(IPv6 interface name)
static: mask not contiguous
static: multipath option not valid for vpn route
static: Non-masked bits not zero for
<Address> mask <Mask>
Static: Non-masked bits not zero for
<Address> masklen <Masklen>
static: not IPv6 prefix
static: out of range
static: poll option not valid for vpn
remote-gateway
static: remote-gateway <IPv6 Prefix> is not
global/site-local IPv6 address
static: syntax error
The total number of {targets|IPv6 static
gateways} (<Value>) is more than the
maximum permitted (256)
5-50
Routing Protocol Error Messages (continued)
More than 255 values are defined in dot notation. Specify value
within the range of 0 to 255.
<Value>: Specified value
Polling count is out of valid range. Specify value within the range of 1
to 10.
<Value>: Specified polling count
Polling timer value is out of valid range. Specify value within the
range of 5 to 180.
<Value>: Specified polling timer value
Polling timer value is invalid. Specify value in the multiples of 5.
Preference value is invalid. Specify a value within the range of 2 to
255.
<Value>: Specified preference value.
VPN number is out of valid range. Specify value within the range of 1
to <Max_Value>.
<Value>: Specified VPN number
<Max_Value>Maximum VPN number
The link local address is specified in the network address. Do not use
the link local address.
The multicast address is specified in the network address. Do not
use the multicast address.
The broadcast interface is specified in the specified interface in the
static definition. To specify the interface, specify the point-to-point
interface.
An interface name is not specified in the specified link local address.
Specify an interface name with the percent (%) interposed when
specifying a link local address.
Bit 1 of the specified mask does not continue. Use a mask where bit
1 continues.
The multipath option has been defined relative to the VPN route.
Do not define the multipath option relative to the VPN route.
In the mask specification, 1 is set to the non-masked bit of the
specified address. Set non-masked bit 0.
<Address>: Specified address
<Mask>: Specified mask
In the masklen specification, 1 is set to the non-masked bit of the
specified address. Set non-masked bit 0.
<Address>: Specified address
<Masklen>: Specified mask length
Addresses other than an IPv6 prefix are specified. Specify IPv6
prefix.
The parameter-specified range is exceeded in the input command
syntax. Numeric values of more than 4294967296 are contained.
Reconfirm a parameter.
Polling option is defines in a VPN remote route. Do not define a
polling option in a VPN remote route.
Addresses other than a global address or site local address are
specified. Specify the global address or site local address for
remote-gateway. <IPv6 Prefix>: Specified local address
Syntax error
Total number of specified targets is more than maximum acceptable
value. Specify a number up to 256.
<Value>: Total number of specified targets
GR2K-GA-0014
Ver. 07-02