Hitachi GR2000 Series Configuration Commands page 215

Default:
Description:
Default:
Range of value:
Description:
Default:
Range of value:
Description:
GR2K-GA-0014
Ver. 07-02
-port_pair_off
Checks upper-level protocol port numbers without switching
the port numbers of the source and destination protocols.
Before specifying the
check function for IP address and upper level protocol port
number to OFF (
-pair_synchronized_off
Define 6 (TCP) or 17 (UDP) for a -protocol parameter when this
parameter is specified. The set value of this parameter is
disabled when a -protocol parameter is undefined or when 6
(TCP) or 17 (UDP) is not defined.
-port_pair
This parameter specifies the port number of an upper-level
source protocol. One port number is specified as
. A port number range is specified as
<Port No.>
<lower limit Port No.>
source and destination upper protocol port numbers are set
under one condition, set so that the specified upper protocol
port numbers do not overlap. If they overlap, set an upper
protocol port number's pair switch as port_pair_off.
Define 6 (TCP) or 17 (UDP) for a -protocol parameter when this
parameter is specified. The set value of this parameter is
disabled when a -protocol parameter is undefined or when 6
(TCP) or 17 (UDP) is not defined.
None (source port numbers are not flow detection conditions).
0-65535
This parameter specifies the port number of an upper-level
destination protocol. One port number is specified as
-port_source <Port No.>
<lower limit Port No.>
destination and source upper protocol port numbers are set
under one condition, set so that the specified upper protocol
port numbers do not overlap. If they overlap, set an upper
protocol port number's pair switch as port_pair_off.
None.
0-65535
This parameter specifies a synchronized check of IP addresses
and upper-level protocol port numbers.
Checks the source and the destination IP addresses, and
upper-level source and destination protocol port numbers
without simultaneously switching the values. Note that the IP
and/or port check will follow the routine of
if either or both of those parameters are specified.
-port_pair
check, set the synchronized
-port_pair
).
-
<upper limit Port No.>
. A range is specified as
-
<upper limit Port No.>
Filtering/QoS Information
-port_source
-port_source
. When both
-port_source
. When both
and/or
-ip_ pair
1-173