Ppp Information; Table 4-8 List Of Initial Values That Can Be Set Using Ppp Information And Initial Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
4.7.8

PPP Information

Input Format
d e f a u l t
Parameters
The initial value items that can be set using PPP Information and the initial values
during initial installation are shown in Table 4-8. For details of each parameter, refer
to the configuration definition information in "PPP Information".
Table 4-8
Information
Group Name
PPP
information
4-42
List of Initial Values that Can Be Set Using PPP Information and Initial
Values During Initial Installation
Information Name
Maximum data length that can be received using PPP
protocol (Maximum value of MTU length in remote router)
Number of Echo-RQ frame retries using PPP protocol
(Link quality monitoring function)
Number of Echo-Reply reception times for judging a
high-quality link using PPP protocol (Link quality
monitoring function)
Echo-RQ transmission interval using PPP protocol (Link
quality monitoring function)
Report of local address to the remote router using PPP
protocol
Operation when the remote router reports IP address using
PPP protocol by IP address negotiation
Report of local IPX node number to the remote router
using PPP protocol
Selection of IPV6CP used or not used by PPP protocol
Initial Value
4500 bytes
7 times
6 times
3 seconds
Not reported.
A correct IP address is
distributed as an IP
address distribution
request (assign).
Not reported.
Used.
GR2K-GA-0014
Ver. 07-02