Qos-Interface; Table 1-74 Relationship Between Priority Determination Among Minimum Bandwidth Guarantee (Kbit/S), Band Control (Traffic Designation), And Flow Control - Hitachi GR2000 Series Configuration Commands

routing protocol information, IP multicast routing protocol information, and
MPLS information are reflected to the operation.
8. When the queue mode is set to the band control (traffic designation) using this
command, set in the same line so that the total of min_rate for the queue of
which traffic type is guarantee, peak_rate for the queue of which traffic type is
constant, and 192 kbit/s for the queue of which traffic type is not set becomes
less than the maximum transmission band of a line.
9. If addition/deletion/change in the parameters is executed in the qos-queue-list
(QoS attribute) in NE100-STB, communication in all of the lines in the same NIF
is temporarily disabled.
Table 1-74 Relationship Between Priority Determination Among Minimum Bandwidth
Method for Deciding
Priority in Flow Control
Designation for out put
priority
Designation for DSCP
rewritten value
Designation for input
packet DSCP value
: Execution possible x :
(*1): Only PR-A1 can be executed.
1.2.3

qos-interface

Applies the QoS queue list to an interface. A maximum of 480 entries may be created
for each RP.
Input Format
Setting information
Modifying information
GR2K-GA-0014
Ver. 07-02
Guarantee (kbit/s), Band Control (Traffic Designation), and Flow Control
Subject
Subject
Configuration
Parameter
Command
qos-ip-list priority_class
flow qos priority
filter-list replace_tos
qos-ip-list replace_tos
flow filter replace_dscp
flow qos replace_tos
qos-ip-list tos-map
flow qos tos-map
Execution impossible.
Filtering/QoS Information
Advisability of Executing Functions of the
Minimum Bandwidth Guarantee (kbit/s
designation), and Band Control (Traffic
Designation)
x
x
x
x
x
x
1-153