Hitachi GR2000 Series Configuration Commands page 340

Hitachi Gigabit Router GR2000 Series Enhanced Version Configuration Commands, Vol. 2
Example
1. Set of log E-Mail information
Set to send log of event level evt to mail address logger@loghost at 9:00, 13:00,
and 17:00:
2. Deletion of log E-Mail information
Delete the setting to send log of event level evt to mail address logger@loghost:
3. Showing of setting information
Show log E-Mail information:
Related Commands
hosts
logger-smtp
dns_resolver
Precautions
Destination mail server must be predefined by logger-smtp.
Host name of this device must be predefined by dns_resolver hostname.
When parameters at and interval are not specified, e-mail is sent whenever the
corresponding event level log occurs. It is recommended to specify at or
interval without the emergency one like err event level.
Confirm if the specified mail address matches to the one defined to
destination mail server. If the sending of e-mail fails, the mail is discarded.
An IP address is used as the source IP address during communication with a
mail server when it is set to the router itself by router-local-address.
This function can be used only with IR4. Therefore, if the host name with the
IPv6 only defined is specified with hosts (host name information) in the SMTP
server, the E-mail addressed to the said server is discarded.
If this command is inputted in the cases where changes are made on the IP
routing protocol information, the IP multicast protocol information, and the
MPLS information, and the apply command is not being executed, the apply
subcommand is executed before the command is executed, and the changed
IP routing protocol information, IP multicast routing protocol information,
and MPLS information are reflected to the operation.
4-10 GR2K-GA-0014
Ver. 07-02