Table 4-12 List Of Initial Values That Can Be Set Using Isdn Information And Initial Values During Initial Installation - Hitachi GR2000 Series Configuration Commands

Parameters
The initial value items that can be set using ISDN Information and the initial values
during initial installation are shown in Table 4-12. For details of each parameter,
refer to the configuration definition information in "ISDN Information".
Table 4-12 List of Initial Values That Can Be Set Using ISDN Information and Initial
Information
Group Name
ISDN
information
GR2K-GA-0014
Ver. 07-02
Values During Initial Installation
Information Name
Use of connection destination
Outgoing/incoming call type
Non-communication monitoring time (just after call
setting)
Non-communication monitoring time (except just after
call setting)
Direction of connection suppression
Number of connection retries when a layer 1 failure
occurs during ISDN connection
Connection retry interval when a layer 1 failure occurs
during ISDN connection
Maximum connection monitoring time
Type of channel used
Maximum value of MTU length in remote router
Number of retries in Echo-RQ frame
Minimum number of reception Echo-Reply times for
judging "high"-quality link
Report of local IP address
Remote IP address mode
Operation Management Information
Initial Value
Can be used.
Used for both outgoing and
incoming calls.
178 seconds
60 seconds
Both outgoing and incoming
calls are suppressed.
Two times
6 seconds
60 minutes
Connection of channel B
4500 bytes
7 times
6 times
The local IP address is not
reported.
A correct IP address is
distributed as an IP address
distribution request.
4-49