SECTION THREE - Interfacing
Page 42
3. Press the 3257 6(783 or 3257 6(783 menu key. On either
screen, the unit displays a list of data format control options, as
shown below.
Check the installation instructions of the equipment to which you're
interfacing for any special requirements. The Northstar factory settings
are adequate for most peripheral equipment, but the following options
are available, if needed:
Table 5: Port setup options
Parameter
OUTPUT FORMAT
(see below)
NMEA 0183 TALKER ID
(see page 45)
NMEA 0183 LL PRECISION
(see page 46)
Options
choose NMEA 0180, NMEA
0183 V2.0, 0183 V1.5, RAY
0183, DATAM CDX, or NONE
choose GP, LC, or II, to make
the unit look like a GPS receiver,
Loran-C receiver, or an "inte-
grated instrument"
choose hundredths of minutes,
thousandths of minutes, or
ten-thousandths of minutes
951/952 INSTALLATION MANUAL Revision B