951/952 INSTALLATION MANUAL Revision B
Figure 12: Correct AN205-P (combo antenna) splitter wiring
Avoid tight bends when installing any antenna cable. Be sure to fasten
the cable along its length to avoid chafing or whipping of any kind.
After you've mounted the antenna and cut the cable to length—not less
than 50 feet—install the supplied TNC connector at the other (952X) end.
See Figure 13, Figure 14, and Figure 15 below. A satisfactory crimp for
this connector may be made with a commonly available, high-quality
crimping tool designed for use with TNC connectors.
Be sure that you properly install the TNC connector: Most sys-
tem failures—whether continuous or intermittent—can be
traced to poor connector installation.
SECTION TWO - Installing the unit
NOTE:
Page 21