Table of Contents
Advertisement
SECTION TWO - Installation
Page 20
ever, that the splitter isn't weatherproof and should be placed in a pro-
tected area where it won't be subjected to direct water splash or spray.
Figure 11: Correct AN205-P (combo antenna) splitter wiring
Avoid tight bends when installing any antenna cable. Be sure to fasten
the cable along its length to avoid chafing or whipping of any kind.
After the antenna has been mounted and the cable has been cut to
length—not less than 20 feet—install the supplied TNC connector at the
other (961X) end. See Figure 12, Figure 13, and Figure 14 below. A satis-
factory crimp for this connector may be made with a commonly available,
high-quality crimping tool designed for use with TNC connectors.
Be sure that you properly install the TNC connector: Most sys-
tem failures—whether continuous or intermittent—can be
traced to poor connector installation.
AS105/AS110
NOTE:
961 INSTALLATION MANUAL Revision A
Advertisement
Table of Contents
Troubleshooting
