Handling Precautions
This product is to inspect (discrimirate/measure) sensing objects.
Never use this product for prevention of accidents which damage a
human life or properties or for safety maintenance.
WARNING
Connection
・The GP-X series is configured to satisfy the specification with the
combination of the sensor head and the controller. Use the sensor head
and controller in combination without fail; with other combinations, not only
・
controller.
・Note that the cables will be damaged if they are pulled.
Power Supply
・Wait 15 minutes (or 20 minutes with GP-XC3SE and GP-X5CSE) after the
the measurements immediately after power-on because the power circuit is
not stable.
・There is a muting time of about two seconds after the power is turned on.
Take care that wrong wiring may damage the sensor.
・
・If power is supplied from a commercial switching regulator, ensure that the
frame ground (F.G.) terminal of the power supply is connected to an actual
ground.
・Make sure to use an isolation transformer for the DC power supply. If an
auto-transformer (single winding transformer) is used, this product or the
power supply may get damaged.
・In case a surge is generated in the used power supply, connect a surge
absorber to the supply and absorb the surge.
Wiring
・
them in the same raceway. This can cause malfunction due to induction.
・
・
・
failure may result.
・
2
Ramco Innovations www.ramcoi.com
Phone 800-280-6933 nsales@ramcoi.com