Panasonic GP-X Series User Manual page 134

1: Use key operation on the controller to assign an address to the controller. The default
refer to section "5.3.2 Connection of Controller Communication Unit and Address
Setting" on page 104.
2: To set three-point calibration data after using a data-writing command for each point,
send an enactment command without fail.
3: The previous mean validity setting is only valid if the press BDC detection mode is
selected as an application mode. If another variation of the application mode is selected,
an error is displayed.
4: The interference prevention function becomes valid when interference I/O cables are
connected at the external input terminals between controllers.
5: If the detection range is exceeded even though the setting is valid as a command
instruction character string, error "20" is sent back.
6: Memory switching cannot be performed unless "panel" is selected for the memory
switching method. If "external input" is selected, error "20" is sent back.
7: The "system reset" command is to restart the controller program. (The sensor goes into
the same state as restarting up state.
8: After initialization of settings, the sensor displays the detection state since it is
automatically reset. The sensor having the 1.10 or later version software does not
require reset of the power supply.
Initialization using an RS-232C command does not initialize the communication
conditions and the controller address.
accumulates in the controller in reference to trigger conditions and, upon completion of
accumulation, the data is loaded via RS-232C communication. About 120,000 points of
data can be accumulated. (Equivalent to about 3 sec. at a sampling frequency of 25
Use optional intelligent monitor software (GP-XAiM
perform data collection easily. For the usage of various commands and details of the
intelligent monitor software (GP-XAiM), contact us.
10: Calculation designation command
In case the command of no calculation (cancel) is sent, if the calculation has been
set, the calculation is canceled. Furthermore, if the cancellation command is sent in
the state that the controller is canceled, the response differs as follows. When the
Controller connected
with RS-232C cable
Address 0 (zero)
Address n
(1 to 7, except 0)
128
Ramco Innovations www.ramcoi.com
Address to Calculation state of
be canceled appointed address
0 (zero) No calculation
No calculation and calculation
is underway in address 0
n
(except zero)
No calculation and no
calculation is in address 0
0 (zero) No calculation
No calculation and calculation
is underway in address 0
n
No calculation and no
(except zero)
calculation is in address 0
GP-X series at high speed temporarily
Error '
% E E ! 0 2 0
Error '
% E E ! n 2 0
No change in state
'
% E E $ W U C n
No response.
Error '
% E E ! n 2 0
No change in state
'
% E E $ W U C n
Phone 800-280-6933 nsales@ramcoi.com
s)
Response
'
C R
'
C R
'
C R
'
C R
'
C R