Panasonic GP-X Series User Manual page 62

4) Select the press BDC detection mode.
After the bottom dead center (BCD) detection mode is selected, a menu
for entering the following settings opens.
・Internal trigger level
・Trigger hysteresis
・Comparison with previous mean valid/invalid
<Detection state>
<Application mode>
5) Enter the tolerance judgment value.
Enter the upper and lower limit values for GO judgment in respect to the reference
・
・Lower limit value (L-thr): Enter the empty stamping judgment value.
56
Ramco Innovations www.ramcoi.com
Press to select "APPLI".
<BDC detection mode>
Internal trigger level setting
Trigger hysteresis setting
Comparison with previous mean valid/invalid setting
(Negative tolerance)
Press to move to another digit.
Press or
*Because the distance is based on about half of the
detection range, the setting range is within
with a 2mm detection range sensor. If a value
exceeding this range is entered, an error is caused.
Press to move to another digit.
Press or
Press or
ON and OFF.
End of entry
Press twice.
State waiting for a trigger
Phone 800-280-6933 nsales@ramcoi.com
to change the number.
1.000
to change the number.
to switch between