Nokia Alfaskop TT/386 User Manual page 96

Help
Using the Maintenance Program
The Maintenance program can be used at any time to check whether
each major part of the system is operating properly.
Preparations
1.
Turn on power to the system as described in the chapter
Operation earlier in this manual.
2. Get the Setup and Maintenance diskette and insert it in
diskette drive A (drive 1).
3.
Press
Ct
rl-A
It- Delete
to reset the system.
After a few seconds the Setup menu is displayed. If you do not want
to change anything in the Setup program, just press the
Esc
key to
pass control to the Maintenance program.
Running the Program
Follow the instructions in the section Running the Maintenance
Program in the chapter Installation at the beginning of this manual.
Examine the error log. If this contains errors or serious warnings,
contact your service representative.
Note: After you have exited the Maintenance program, you are
asked to remove the Maintenance Program diskette and insert the
DOS diskette in its place. Ignore this! Insertion of the DOS diskette
applies only to the initial installation of the system. Just remove the
Maintenance Program diskette and reset the system by pressing Ctrl-
Alt-Delete.
4-28