Running The Setup Program - Nokia Alfaskop TT/386 User Manual

Installation
Running the Setup Program
The intention of the description on the following pages is to provide
the information necessary to help you get your system running, not
to give a complete description of the Setup program.
Later on, when you need more information about what you can do
with the Setup program, you can refer to the complete description in
the chapter Help later in this manual.
To run the Setup program, do as follows:
1. Turn switch on the back panel of the system unit to "1"
position.
2. Turn the key on the front panel of the system unit to RUN
position. The green indicator led lights up.
3. Turn on power to the monitor.
4. The system unit now performs a power-on self test to check
that the system is functioning properly.
4a. If all went well during the power-on test, one long beep is
heard from the system unit's built-in loudspeaker. After the
monitor has warmed up, the screen might look something like
this:
Alfaskop TT/386 ROM BIOS Version 1.04 (A)
Copyright Nokia Data System AB 1988
640 kB Base memory
1024 kB Extra memory
Waiting. .
4b. If anything went wrong during the power-on test, two long
beeps are heard. The text 'Waiting" is not displayed. Instead
one or more error messages are displayed, followed by the
prompt:
Press Fl to continue
2-6