Running The Maintenance Program - Nokia Alfaskop TT/386 User Manual

Installation
Running the Maintenance Program
The Maintenance program is invoked automatically after you have
exited the Setup program. The Maintenance program carries out a
number of pre-programmed tests in sequence to check that the major
system components are functioning properly.
After a few seconds the System Configuration is displayed. The
screen might look something like this:
■
MAI NT V4.30c - ...............—
S Y S T E M C O N F I G U R A T I O N 21.04.1988 09.41.27
BIOS and ( setup ) c o n f i g u r a t i o n f o r Nokia Alfaskop TT/386:
BIOS v e r s i o n ; 88-04-12 RID
D i s k e t t e d r i v e ( s ) ; 1: 1 . 4 MB ( 1 . 4 MB )
Hard d i s k ( s ) ; 1: 43.6 MB ( 4 3 . 6 MB)
Streamer; not a v a i l a b l e
Co-processor (80387); a v a i l a b l e , ( a v a i l a b l e )
Base memory s i z e ; 640 kB ( 640 kB )
Expansion memory s i z e ; 3072 kB ( 3072 kB )
S e r i a l channels; COMI
P r i n t e r channels; LPT1
I n i t i a l video mode; C o l o r / G r a p h i c , 80, ( )
Running a t 16 MHz, 0 w a i t s t a t e
Press Enter t o c o n t i n u e .............
The values given within parentheses are the values from the Setup
program. These values should normally agree with the values in
front of them, which indicate what the system itself assumes.
There are two points to note before you press Enter to continue:
1. If you have installed a second diskette drive in the system
unit:
• Insert a formatted diskette in diskette drive B (drive 2).
You can use any diskette; it need not be blank, and it
may be write-protected.
2-12