Nokia Alfaskop TT/386 User Manual page 92

Help
Go to step 3.
2b. Changing the present password:
Type the present password and press Enter.
3. Type the new password and press Enter.
4. Type the new password again and press Enter.
You can also stop using a password. Proceed as described above,
but press just Enter when you are asked to enter the new password.
Note: Write down the password, and save the note in a safe place.
Boot select Standard - Drive 2 enabled
- Diskette disabled
Standard. If a boot diskette is inserted in diskette drive A (drive 1)
when the power-on test has been executed, or the system has been
reset, the disk operating system, DOS, is booted (loaded) from this
diskette. If no diskette is inserted in diskette drive A, DOS is booted
from the hard disk, provided that this contains DOS.
Drive 2 Enabled. If your system has a second diskette drive, the
diskette in this drive can be used to boot DOS, provided that no boot
diskette is inserted in diskette drive A (drive 1).
Diskette Disabled means that DOS cannot be booted from a
diskette, only from the hard disk. This allows a non-system diskette
to be permanently inserted in diskette drive 1 (drive A); the
operating system will always be booted from the hard disk.
Exiting the Security Menu
When you are finished with the Security menu, press the Esc key to
return to the Setup menu.
4-24