Table of Contents
Advertisement
1.
Push down the PTO switch.
2.
Start the engine; refer to
(page
42).
3.
Pull up the PTO switch.
Understanding Turnaround
Mode
Engage the turnaround mode whenever you install
the flail mower (Model 02835).
Turnaround mode allows you to quickly raise the flail
mower above the turf when completing a quick turn at
the end of a mowing pass, or while navigating around
obstacles.
When you lower the flail mower to the O
position, you can quickly press and release the
attachment lift switch rearward to slightly raise the
flail when you perform a quick turn. Once you have
completed the turn, press the lift switch to lower the
flail back to the ground and resume mowing.
Shutting Off the Engine
1.
Use the throttle control to lower the engine
speed.
2.
Move the PTO switch to the O
3.
Rotate the key switch to the O
remove the key from the switch.
After Operation
After Operation Safety
General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or hauling the machine.
Starting the Engine
PERATING
position.
FF
position and
FF
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Maintain and clean the seat belt(s) as necessary
Servicing the Cutting Unit
You can rotate the cutting unit from the T
position (A in
Figure
Figure
37). Use the S
cutting unit blades or clean underneath the cutting
unit; refer to your cutting unit Operator's Manual.
1. T
position
RANSPORT
Rotating the Cutting Unit to the
S
Position
ERVICE
Perform this procedure to rotate the cutting unit from
the T
position to the S
RANSPORT
43
RANSPORT
37) to the S
position (B in
ERVICE
position to maintain the
ERVICE
Figure 37
2. S
position
ERVICE
position.
ERVICE
g258473
Advertisement
Table of Contents
