Toro 31900A Operator's Manual page 38

WARNING
There is no rollover protection when the roll
bar is lowered.
• Do not operate the machine on uneven
ground or on a hill side with a lowered roll
bar.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar
is lowered.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance
permits.
• Check carefully for overhead clearances
(e.g., branches, doorways, or electrical
wires) before driving under any objects
and do not contact them.
Lowering the Roll Bar
Important:
Lower the roll bar only when
absolutely necessary.
1. Park the machine on a level surface, engage the
parking brake, lower the cutting unit, shut off the
engine, and remove the key.
2. Remove the cotter pins and pins from the roll
bar (Figure 33).
3. Lower the roll bar and secure it in place with the
pins and cotter pins (Figure 33).
Raising the Roll Bar
1. Park the machine on a level surface, engage the
parking brake, lower the cutting unit, shut off the
engine, and remove the key from the key switch.
2. Remove the cotter pins and pins from the roll
bar (Figure 34).
3. Raise the roll bar and secure it in place with the
pins and cotter pins
38
Figure 33
(Figure 34).
g257846
g034164