Using Bootable Usb Storage Device To Restore - Canon ImagePRESS Server H350 V2 Service Manual

Using bootable USB storage device to restore

Use the following procedure when you restore the system without using the System Software DVD 1, or when the imagePRESS
Server does not boot from the built-in hard disk drive.
You can restore from the bootable backup media (including the Fiery factory image) created by either Backup and Restore or
Fiery System Installer.
To restore the system from bootable USB storage device
To restore from the bootable USB storage device, you must have created a backup with the Create bootable media option. If you
have created a backup as bootable backup image, follow these instructions.
NOTE:
You can use this procedure to also install the system software after you replaced the HDD with a new one.
1. Shut down theimagePRESS Server.
2. Attach the bootable USB backup media to the imagePRESS Server.
Make sure to remove any media in the DVD drive. Do not attach other USB devices to the imagePRESS Server.
3. Press the power button to turn on the imagePRESS Server.
The imagePRESS Serverwill boot from the bootable USB backup media.
4. Follow the instructions on the Fiery QuickTouch display or the monitor (if available) to restore the backup image.
5. PERFORMING BACKUP AND RESTORE
75