Canon ImagePRESS Server H350 V2 Service Manual page 63

4. Remove the SATA power cables from the hard disk drives.
5. Detach the SATA power cable from the power connector of the dual cable for the DVD drive.
6. Detach the 8-pin power cable from the connector from the Fiery QuickTouch.
7. Remove any tie-wraps securing the power cables to the chassis.
8. Place the imagePRESS Server in the upright position.
9. Remove the motherboard from the chassis (see
10. Remove the four connector panel screws that secure the power supply to the back of the chassis (see below).
11. While squeezing the power supply unit, remove the inside screw with washer.
12. Slide the power supply toward the front panel and take the power supply off from under the chassis bar.
No.
1 Power supply unit
2 Chassis bar
NOTE:
To service the power supply, place the imagePRESS Server in an upright position.
■ To replace the power supply
1. Make sure that the imagePRESS Server is in upright position.
2. Position the power supply inside the chassis (see
Insert the power supply unit under the chassis bar, and place the power supply on top of the left and right chassis bars.
Position the power supply so that it is flush against the connector panel.
3. Install the inside screw with washer to secure the power supply unit to the chassis top.
4. Install the four screws that secure the power supply to the connector panel of the chassis.
5. Replace the motherboard (see
6. Connect one of the SATA power cables to the power connector on the dual data/power cable that connects to the DVD drive.
"To replace boards, cables, and components" on page
Figure 33: Removing/replacing the power supply
Item
"To remove the power supply" on page
"To replace the motherboard" on page
No.
3 Screw (1 of 4)
4 Inside screw
45)
56
4. REPLACING PARTS
46)
4
1
2
3
Item
55)