Table of Contents
Advertisement
● To download the system logs
1. Start a web browser and access the imagePRESS Server by entering the server name or IP address of the imagePRESS
Server.
NOTE:
If a message about an untrusted connection appears or you are asked whether you want to proceed, you can safely ignore
the message and proceed by clicking Continue to website.
2. In WebTools, click the Configure tab.
3. Log on with Administrator privileges and click OK.
The default password for Administrator is Fiery password(See
administrator may have changed the password.
4. On the left side, choose Fiery Server > System Logs > Download.
5. Specify the location and save the system log file.
Cleaning the imagePRESS Server
The accumulation of dust on the fans may cause the following problems.
• High temperature inside the chassis
• Noise from the fans
• Short-circuit or damage on the board assembly
As a regular maintenance, it is important to remove dust on the fans and air duct to keep the airflow inside the chassis.
WARNING:
Before you open the imagePRESS Server, it is strongly recommended that you review
injury or damage to the imagePRESS Server.
In addition, keep following in mind:
• To prevent inhaling dust, make sure to wear a mask when cleaning inside chassis.
• If possible, create a backup of the current system before cleaning the imagePRESS Server
Restore" on page
64).
• When cleaning the imagePRESS Server, make sure to move the imagePRESS Server to a place where the stirred dust does
not cause any problems.
• Use appropriate cleaning tools.
• Vacuum cleaner
Use vacuum cleaner only to remove the accumulated dust outside the chassis.
• Air dust blower
Use a air blower when you remove the dust on the fans, or other area where the vacuum cleaner nozzle cannot be used.
"How to obtain the Fiery password" on page
95
7. TROUBLESHOOTING
8), but the site
"Precautions " on page 3
to avoid
(see"Performing Backup and
Advertisement
Table of Contents
