Table of Contents
Advertisement
6. Work with the network administrator to configure the IP address settings manually.
• Disable Get IP address automatically and enter the IP address.
• Enter the subnet mask.
• Disable Get DNS address automatically and enter the DNS address.
7. Save the settings and close Setup.
● To configure a static IP address for the imagePRESS Server(Fiery QuickTouch)
1. On the Fiery QuickTouch Home screen, press the Quick launch icon on the bottom-left corner.
2. Select Settings, and log in to the server as Admin user (the default password is Fiery password).(See
Fiery password" on page
3. Select Configure IP Address, and select IP Address, DNS, Subnet Mask, WINS, and Default Gateway, as necessary.
4. Save the settings and exit.
● Reserved IP addresses
The following subnet mask is reserved for internal use and should never be assigned as an IP address to the imagePRESS
Server or to any other device on the customer network:
• 10.255.255.x (for example, 10.255.255.1 or 10.255.255.2)
IMPORTANT:
Assigning any of these IP addresses will result in system corruption of the imagePRESS Server, and you will need to
reinstall system software to fix the problem.
■ Completing installation
To complete the installation of the imagePRESS Server at the customer site, do the following:
1. Makes sure that the printer is powered on.
2. Power on the imagePRESS Server (see
3. Wait for the system to power on and for the imagePRESS Server info screen to reach idle.
NOTE:
If the message "Check power and cable" displays on the printer touch panel, verify that the printer interface cable is connected
properly to the printer and the imagePRESS Server.
4. Perform any required system software upgrades. For instructions, see the documentation that accompanies the imagePRESS
Server system upgrade.
Updates to imagePRESS Server software may be available from a variety of sources (for example, System Updates
(see"Installing software patches" on page
Windows operating system updates should be obtained from Microsoft directly. Because such updates are available directly
from Microsoft, EFI does not maintain or provide them via the System Updates feature.
5. Print the Test Page and Configuration page and ask the customer to verify the output (see
pages from the monitor, keyboard, and mouse" on page
6. If the imagePRESS Server requires a static IP address (for example, in a non-DHCP network environment), work with the
network administrator to configure a static IP address (see
page
17)
7. Change the factory default language, if needed. For more information on changing the factory default language, see
the language of the imagePRESS Server" on page
8. Ask the network administrator to perform Setup and print some test documents over the network.
9. Store the output and the current Configuration page(s) near the printer.
10. Inform the site administrator that the imagePRESS ServerimagePRESS Server user software must be installed on networked
computers that print to the imagePRESS Server.
11. Ask the site administrator to make sure that all media (DVDs and/or CDs) shipped with the imagePRESS Server is stored
in a safe location, accessible to you.
8)
"Starting the imagePRESS Server for the first time" on page
83) or patches downloaded by the customer).
11.
20)
"Configuring a static IP address for the imagePRESS Server" on
18
2. INSTALLING HARDWARE
"How to obtain the
17)
"Printing imagePRESS Server
"Change
Advertisement
Table of Contents
