Table of Contents
Advertisement
Installing Hardware
About the installation process
It is strongly recommended that you review this chapter before you install the imagePRESS Server. Also keep in mind that
installation problems are easier to avoid and diagnose if you proceed from the component level to the system level, verifying
functionality at each step.
Since the imagePRESS Server is connected to the customer's network, be sure to coordinate your installation schedule with the
administrator at the customer site. For information about network setup, refer the site administrator to Configuration Guide, which
is part of the user documentation set.
If necessary, you can change the default language of the imagePRESS Server set at the factory (see
the imagePRESS Server" on page
■ To install the imagePRESS Server
1. Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
2. Unpack the imagePRESS Server (see
3. If applicable, connect the monitor, keyboard, mouse, and furniture to the imagePRESS Server.
For more information on setting up the furniture, see the documentation that comes with the furniture kit.
4. Connect the following cables (see
• Power cable
• Printer interface cable
• Network cable (upper RJ-45)
• Crossover Ethernet cable (lower RJ-45)
5. (Optional) If the imagePRESS Server requires a static IP address (for example, in a non-DHCP network environment), work
with the site administrator to configure a static IP address (see
on page
17)
6. Complete the installation (see
Remind site administrator to install current user software on client computers that print to the imagePRESS Server (see
Printing and Utilities, which are part of the user documentation set).
■ Change the language of the imagePRESS Server
If necessary you can change the language of the imagePRESS Server set at the factory.
To change the imagePRESS Server language from Fiery QuickTouch
1. On the Fiery QuickTouch Home screen, select Quick Launch > Settings (see Figure 10
menu options" on page 22
2. Log in to the imagePRESS Server as Administrator.
The default password for the Administrator is Fiery password(See
3. Select Language, and then from the Select language drop-down, select the language you want.
4. Press Save Changes.
5. Press Reboot.
Wait until the imagePRESS Server reboots and becomes Idle. It may take up to 15 minutes to complete the system language
change.
To change the imagePRESS Server language from Configure
1. Access Configure (see
2. In Configure, click Fiery Server > Regional Settings,
3. In the Server Language drop-down list, select a language.
4. Click Save.
5. Click Continue, then click Reboot.
Wait until the imagePRESS Server reboots and becomes Idle. It may take up to 15 minutes to complete the system language
change.
Checking the customer site
Before you install the imagePRESS Server, check the site conditions and inform the customer of any installation requirements.
11).
"Checking the customer site" on page
"Connecting the imagePRESS Server" on page
"Completing installation" on page
).
"About Configure" on page
"Network" on page
"Configuring a static IP address for the imagePRESS Server"
18)
"How to obtain the Fiery password" on page
21).
11
2. INSTALLING HARDWARE
"Change the language of
12)
11)
13)
on"Overview of Fiery QuickTouch
8).
Advertisement
Table of Contents
