Table of Contents
Advertisement
■ To configure the system date and time
1. Access WebTools.
1. On a client computer that is connected to the same network as the imagePRESS Server, open a Web browser window.
2. In the URL field of the browser, type the IP address or DNS name of the imagePRESS Server, and press Enter.
The IP address is listed under the Network Setup section of the imagePRESS Server Configuration page.
2. In WebTools, click the Configure tab.
3. Type the administrator account in User name and the corresponding password in Password, then click Log In.
You can enter "Administrator" or "admin" for the administrator account name. The default password is Fiery password.(See
"How to obtain the Fiery password" on page
imagePRESS Server.
4. Select Fiery Server > Regional Settings and specify the current date and time, and click Save.
5. Click Log Out to exit Configure.
Jumpers
Jumper configurations should not be changed.
Jumper
J101 is the Clear CMOS and Password jumper. Default configuration: jumper cap installed on pins 1and 2.
J101
Pin 1
Fan
A fan mounted inside the imagePRESS Server chassis draws air into the imagePRESS Server to cool components. The fan runs
continuously when the system is on. You should hear the fan start as soon as you power on the imagePRESS Server. If you do
not hear the fan, there may be a faulty power connection.
The following procedures describe how to remove and replace the fan.
■ To remove the fan
1. Shut down, and then open the imagePRESS Server (see
To access the fan, you must remove the left panel.
2. Remove the fan cable from motherboard connector FRONT FAN (J20).
8) However, the site administrator may have configured a new password for the
NOTE:
It is not necessary to clear the CMOS settings when servicing motherboard components, the DVD
drive, and the hard disk drive.
Description
"Shutting down the system" on page
54
4. REPLACING PARTS
33) .
Advertisement
Table of Contents
