Engine - Toro Groundsmaster 7200 Series Operator's Manual

Traction unit
Hide thumbs Also See for Groundsmaster 7200 Series:
Table of Contents

Advertisement

7.
Lightly sand and use touch up paint on painted
areas that are scratched, chipped or rusted.
Repair any dents in the metal body.
8.
Service the battery and cables as follows:
A.
Remove the battery terminals from the
battery posts.
B.
Clean the battery, terminals, and posts with
a wire brush and baking soda solution.
C.
Coat the cable terminals and battery posts
with Grafo 112X skin-over grease (Toro Part
No. 505-47) or petroleum jelly to prevent
corrosion.
D.
Slowly recharge the battery for 24 hours
every 60 days to prevent lead sulfation of
the battery.

Engine

1.
Drain the engine oil from the oil pan and replace
the drain plug.
2.
Replace the oil filter.
3.
Fill the engine with the recommended motor oil.
4.
Start the engine and run it at idle speed for 2
minutes.
5.
Drain the fuel from the fuel tank, fuel lines,
pump, filter, and separator. Flush the fuel tank
with clean diesel fuel and connect all fuel lines.
6.
Thoroughly clean and service the air-cleaner
assembly.
7.
Seal the air-cleaner inlet and the exhaust outlet
with weather proof masking tape.
8.
Check the oil filler cap and fuel-tank cap to
ensure that they are securely in place.
53

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 7210 series30487tc3049530495tcGroundsmaster 7200Groundsmaster 7210

Table of Contents