Transporting The Machine - Toro Groundsmaster 7200 Series Operator's Manual

Figure 25
1. Right bypass valve
3. Ensure that the parking brake is disengaged and
push the machine to the desired location.
4. Close the valves by rotating each valve 1
clockwise turn (Figure
Note:
Do not overtighten the valves.
5. Torque the valves to approximately 8 N∙m (71
in-lb).
Important:
Ensure that the bypass valves
are closed before you start the engine.
Running the engine with open bypass valves
causes the transmission to overheat.
g004644
2. Left bypass valve
25).

Transporting the Machine

Use a heavy-duty trailer or truck to transport the
machine. Ensure that the trailer or truck has all
the necessary brakes, lighting, and marking as
required by law. Please carefully read all the safety
instructions. Knowing this information could help you,
your family, pets, or bystanders avoid injury.
WARNING
Driving on the street or roadway without
turn signals, lights, reflective markings, or a
slow-moving-vehicle emblem is dangerous
and can lead to accidents causing personal
injury.
Do not drive the machine on a public street
or roadway.
1. If you are using a trailer, connect it to the towing
vehicle, and connect the safety chains.
2. If applicable, connect the trailer brakes.
3. Load the machine onto the trailer or truck; refer
to Loading the Machine (page
4. Shut off the engine, remove the key, engage the
parking brake, and close the fuel valve.
5. Use the tie-down loops on the machine to
securely fasten it to the trailer or truck with
straps, chains, cable, or ropes
1. Traction unit tie-down loops
29
30).
(Figure 26).
Figure 26
g191318