Using The Safety-Interlock System - Toro Groundsmaster 7200 Series Operator's Manual

Traction unit
Hide thumbs Also See for Groundsmaster 7200 Series:
Table of Contents

Advertisement

Raising the Roll Bar
Raise the roll bar as shown in
Figure 10
Important:
Always use the seat belt when the
roll bar is in the raised and locked position. Do
not use the seat belt when the roll bar is in the
lowered position.
Figure
10.
g031624
g031631
Using the Safety-Interlock
System
CAUTION
If the safety-interlock switches are
disconnected or damaged, the machine could
operate unexpectedly, causing personal
injury.
• Do not tamper with the interlock switches.
• Check the operation of the interlock
switches daily and replace any damaged
switches before operating the machine.
Understanding the
Safety-Interlock System
The safety-interlock system prevents the engine from
starting unless:
You are sitting on the seat or the parking brake
is engaged.
The power takeoff (PTO) is disengaged.
The motion-control levers are in the N
position.
The engine temperature is below the maximum
operating temperature.
The safety-interlock system also shuts off the
engine when you move the traction controls from
the N
-
position with the parking brake
EUTRAL
LOCK
engaged. If you rise from the seat when the PTO
is engaged, there is a 1-second delay and then the
engine shuts off.
Testing the Safety-Interlock
System
Service Interval: Before each use or daily
Test the safety-interlock system before you use the
machine each time. If the safety system does not
operate as described below, have an Authorized
Service Dealer repair the safety system immediately.
1.
Sit on the seat, engage the parking brake, and
move the PTO to the O
the engine; the engine should not crank.
2.
Sit on the seat, engage the parking brake,
and move the PTO to the O
Move either motion-control lever out of the
N
-
EUTRAL
LOCK
the engine should not crank. Repeat for other
motion-control lever.
3.
Sit on the seat, engage the parking brake, move
the PTO switch to the O
the motion-control levers to the N
20
EUTRAL
position. Try starting
N
position.
FF
position. Try starting the engine;
position, and move
FF
EUTRAL
-
LOCK
-
LOCK

Advertisement

Table of Contents
loading

This manual is also suitable for:

Groundsmaster 7210 series30487tc3049530495tcGroundsmaster 7200Groundsmaster 7210

Table of Contents