Adjusting The Maximum Ground Speed - Toro Groundsmaster 7200 Series Operator's Manual

Figure 51
1. Right pump rod
2. Left pump rod
3. Ball joint
4. Bolt
7. Move the motion-control lever forward and
reverse, then back to neutral.
Note:
The wheel must stop turning or slightly
creep in reverse.
8. Move the throttle lever to the F
Note:
Make sure that the wheel remains
stopped or slightly creeps in reverse; adjust it
if necessary.
9. Repeat steps 6 through
the machine.
10. Tighten the jam nuts at the ball joints
11. Move the throttle lever to the S
shut off the engine.
12. Remove the jumper wire from the wire harness
connector and plug the connector into the seat
switch.
g004488
5. Jam nut
6. Hex shaft
7. Ball joint
position.
AST
8 for the other side of
(Figure 49).
position and
LOW
WARNING
The electrical system does not perform
proper safety shutoff with the jumper
wire installed.
• Remove the jumper wire from the
wire harness connector and plug the
connector into the seat switch when
you complete adjustment.
• Never operate the machine with the
jumper installed and the seat switch
bypassed.
13. Lower the seat into position.
14. Remove the jack stands.
Adjusting the Maximum
Ground Speed
1. Disengage the PTO, move the motion-control
levers to the N
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Remove the bolts securing the front panel and
remove the panel
1. Bolt
2. Control panel
4. Loosen the jam nut on the stop bolt for a control
lever (Figure 53).
48
- position, and
EUTRAL LOCK
position,
LOW
(Figure 52).
Figure 52
g020875