Cleaning; Cleaning Under The Mower; Waste Disposal; Storage - Toro Groundsmaster 7200 Series Operator's Manual

Cleaning

Cleaning Under the Mower

Service Interval: Before each use or daily
1. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
2. Move the throttle lever to the S
shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3. Raise the mower to the transport position.
4. Raise the front of the machine using jack stands.
5. Thoroughly clean the underside of the mower
with water.

Waste Disposal

Engine oil, batteries, hydraulic fluid, and engine
coolant are pollutants. Dispose of these according to
your state and local regulations.
- position, and
LOCK
position,
LOW

Storage

Machine

1. Shut off the engine and remove the key. Wait for
all movement to stop and allow the machine to
cool before you adjust, clean, store, or repair it.
2. Thoroughly clean the machine, deck, and
engine, paying special attention to these areas:
•
Radiator and radiator screen
•
Underneath the deck
•
Under the deck belt covers
•
Counterbalance springs
•
PTO-shaft assembly
•
All grease fittings and pivot points
•
Inside the control box
•
Beneath the seat plate and top of the
transmission
3. Check and adjust front and rear tire pressure;
refer to Checking the Tire Pressure (page
4. Remove, sharpen, and balance the mower
blades. Install the blades and torque the blade
fasteners to 115 to 149 N∙m (85 to 110 ft-lb).
5. Check all fasteners for looseness and tighten
them as necessary. Torque the 6 bolts securing
the mower deck frame to the traction unit
58) to 359 N∙m (265 ft-lb).
Right side not shown.
1. Bolts
6. Grease or oil all grease fittings, pivot points, and
transmission-bypass-valve pins. Wipe off any
excess lubricant.
52
Figure 58
41).
(Figure
g004905