Adjusting The Traction Drive For Neutral - Toro Groundsmaster 7200 Series Operator's Manual

Figure 50
1. N position
EUTRAL
7. If adjustment is needed, loosen the nut and jam
nut against the yoke
8. Applying slight rearward pressure on the
motion-control lever, turn the head of the
adjustment bolt in the appropriate direction until
the control lever is centered in the N
position (Figure 49).
Note:
Rearward pressure on the lever keeps
the pin at the end of the slot and allow the
adjustment bolt to move the lever to the
appropriate position.
9. Tighten the nut and jam nut
10. Repeat steps 4 through
lever.
11. Install the front panel.
Adjusting the Traction
Drive for Neutral
Make this adjustment with the drive wheels turning.
DANGER
Mechanical or hydraulic jacks may fail to
support the machine and cause a serious
injury.
• Use jack stands when supporting the
machine.
• Do not use hydraulic jacks.
2. N - position
EUTRAL LOCK
(Figure 49).
-
EUTRAL LOCK
(Figure 49).
9 for the other control
WARNING
The engine must be running to perform this
adjustment. Contact with moving parts or hot
surfaces may cause personal injury.
Keep hands, feet, face, clothing, and other
body parts away from rotating parts, muffler,
and other hot surfaces.
1. Raise the frame onto stable jack stands so that
the drive wheels can rotate freely.
2. Slide the seat forward, unlatch it, and swing it up
and forward.
3. Disconnect the electrical connector from the
g004918
seat safety switch.
4. Temporarily install a jumper wire across the
terminals in the wire harness connector.
5. Start the engine, ensure that the throttle lever is
midway between the F
and release the parking brake.
Note:
The motion-control levers must be in
the N
EUTRAL
adjustments.
6. Adjust the pump rod length on one side by
rotating the hex shaft, in the appropriate
direction, until the corresponding wheel is still or
slightly creeping in reverse
47
and S
AST LOW
- position while you make any
LOCK
(Figure
positions,
51).