Cleaning; Removing Debris; Washing The Machine - Toro e-Dingo 500 Operator's Manual

Note:
Dispose of used fluid at a certified
recycling center.
9. Install the fan shroud.
10. Install the lower front cover and the hood.
11. Remove and store the cylinder locks and lower
the loader arms.

Cleaning

Removing Debris

Service Interval: Before each use or daily
1. Park the machine on a level surface, remove
any attachment, raise the loader arms, and
install the cylinder locks.
2. Shut off the machine and remove the key.
3. Clean any debris from the machine.
Important:
Blow the dirt out rather than
wash it out. If you use water, keep it away
from electrical items and hydraulic valves.
Clean electrical connectors using
compressed air; do not use contact cleaner.
4. Remove and store the cylinder locks and lower
the loader arms.

Washing the Machine

If you must pressure wash the machine, do the
following:
Important:
Do not clean the machine with water
while it is charging. Ensure machine is dry before
charging.
•
Wear appropriate personal protective equipment
for the pressure washer.
•
Keep all guards in place on the machine.
•
Avoid spraying at electronic components.
•
Avoid spraying at edges of decals.
•
Spray the exterior of the machine only. Do not
spray directly into openings in the machine.
•
Spray only the dirty parts of the machine.
•
Use a 40-degree or larger spray nozzle. 40-degree
nozzles are usually white.
•
Keep the tip of the pressure washer at least 61 cm
(2 ft) away from the surface being washed.
•
Use only pressure washers with pressure below
13790 kpa (2000 psi) and flow below 7.6 L (2 US
gallons) per minute.
•
Replace damaged or peeling decals.
•
Grease all grease points after washing; refer to
Greasing the Machine (page
37
29).