Changing The Hydraulic Fluid - Toro 30609 Operator's Manual

Figure 95
Changing the Hydraulic
Fluid
Service Interval: Every 800 hours
If the fluid becomes contaminated, contact your
local Toro distributor because the system must be
flushed. Contaminated fluid looks milky or black when
compared to clean oil.
1. Position the machine on a level surface, lower
the mower decks, shut off the engine, and
remove the key.
2. Remove the drain plug from the bottom, front of
the reservoir and let the hydraulic fluid flow into
a large drain pan.
3. Install and tighten the plug when the hydraulic
fluid stops draining.
4. Fill the reservoir
refer to Checking the Hydraulic Fluid (page
Important:
specified. Other fluids could cause system
damage.
g033354
1. Hydraulic reservoir
5. Install the reservoir cap, start the engine, and
use all of the hydraulic controls to distribute
hydraulic fluid throughout the system.
6. Check for leaks; then shut off the engine.
7. Check the fluid level and add enough to raise
level the level to the Full mark on the dipstick.
Note:
Do not overfill.
68
(Figure 96) with hydraulic fluid;
Use only the hydraulic fluids
Figure 96
67).
g020456