Adjusting The Skids; Adjusting The Cutting Unit Rollers - Toro 30609 Operator's Manual

Figure 23
8. Insert the clevis pins and install the hairpin
cotters.
9. Rotate the tension rod counterclockwise (finger
tight) to put tension on adjustment.

Adjusting the Skids

The skids should be mounted in the lower position
when operating at heights of cut greater than 64
mm (2-1/2 inches) and in the higher position when
operating at heights of cut lower than 64 mm (2-1/2
inches).
Note:
When the skids become worn, you can switch
the skid to the opposite sides of the mower, flipping
them over. This will allow you to use the skids longer
before replacing them.
Note:
Torque the screw at the front of each skid to 9
to 11 N⋅m (80 to 100 in-lb).
decal100-5623nc
Adjusting the Cutting Unit
Rollers
The cutting unit rollers should be mounted in the lower
position when operating in height of cuts greater than
64 mm (2-1/2 inches) and in the higher position when
operating in height of cuts lower than 64 mm (2-1/2
inches).
1. Remove the bolt and nut securing the gage
wheel to the cutting unit brackets
1. Gage wheel
29
Figure 24
(Figure
Figure 25
g031063
25).
g011493