Toro 30609 Operator's Manual page 16

Parking-Brake Latch
A knob on the left side of the console actuates the
parking-brake lock (Figure
To engage the parking brake, connect the pedals with
the locking latch, push down on both pedals, and pull
the parking-brake latch out. To release the parking
brake, press both pedals until the parking-brake latch
retracts.
Hazard-Light Switch (Optional)
Press the hazard-light switch to activate the hazard
lights (Figure 3).
Turn-Signal Switch (Optional)
Press the left side of the turn-signal switch to activate
the left-turn signal and the right side of the switch to
activate the right-turn signal
Key Switch
The key switch (Figure
O /P , and S
N REHEAT TART
3
2
4
5
6
7
1. Lift switches
2. PTO switch
3. Key switch
4. InfoCenter
Engine-Speed Switch
The engine-speed switch has 2 modes to change the
engine speed (Figure 4).
By momentarily tapping the switch, you can increase
or decrease the engine speed in 100-rpm increments.
When you hold the switch down, the engine
automatically moves to H
on which side of the switch you press.
3).
(Figure 3).
4) has 3 positions: O
.
1
Figure 4
5. High-Low speed control
6. Engine-speed switch
7. Light switch (optional)
or L , depending
IGH OW IDLE
PTO Switch
The PTO switch has 2 positions: O
I ( ). Pull the PTO button out to engage the
N STOP
mower-deck blades. Push the button in to disengage
the mower-deck blades
High-Low Speed-Control Switch
The High-Low speed-control switch allows the speed
range to increase for transport of the machine
4).
Mower decks do not operate in high range. To switch
between the H
disengage the PTO, disengage the cruise control,
move the traction pedal in the N
move the machine at a slow speed.
Lift Switches
The lift switches raise and lower the mower decks
(Figure 4). Press the switches forward to lower the
mower decks and rearward to raise the mower decks.
When starting the machine, with the mower decks in
,
FF
the down position, press the lift switch down to allow
the mower decks to float and mow.
Note:
The decks do not lower while in the High-speed
range and they do not raise or lower if the operator is
out of the seat when the engine is running. Also, the
decks lower with the key in the O
operator in the seat.
Cruise-Control Switch
The cruise-control switch locks in the pedal position
to maintain the desired ground speed
g028453 Pressing the rear of the switch turns off the cruise
g028453
control, the middle position of the switch enables the
cruise-control function, and the front of the switch sets
the desired ground speed.
Note:
Pressing either brake pedal or moving the
traction pedal into the R
also disengages the pedal position.
16
UT
(Figure 4).
and L range, raise the decks,
IGH OW
EUTRAL
position and the
N
position, for 1 second,
EVERSE
( ) and
START
(Figure
position, and
(Figure 5).