Toro Groundsmaster 3300 Operator's Manual page 44

2. Press the lift switch to raise the cutting unit to
the T position.
RANSPORT
3. Engage the parking brake, shut off the engine,
and remove the key.
4. Remove the pins from the height-of-cut plates
(Figure 38).
Figure 38
1. Height-of-cut pins
5. Rotate the cutting unit
latch engages with the tie-down bracket
40).
WARNING
The cutting unit is heavy.
Use assistance when you lift the cutting
unit.
Figure 39
g258474
2. Height-of-cut plates
(Figure 39) so that the
(Figure
g298275
Rotating the Cutting Unit to the
T Position
RANSPORT
Perform this procedure to rotate the cutting unit from
the S position to the T
ERVICE
1. Release the cutting-unit latch from the tie-down
bracket (Figure
unit slightly forward (refer to
pulling the latch handle forward.
2. Slowly rotate the cutting unit down until the pin
contacts the lift-arm plate (A in
44
Figure 40
position.
RANSPORT
41) by slightly rotating the cutting
Figure 39) and
Figure 41
Figure
g298276
g298277
42).