After Operation; After Operation Safety; Servicing The Cutting Unit - Toro Groundsmaster 3300 Operator's Manual

2. Move the PTO switch to the O
3. Rotate the key switch to the O
remove the key from the switch.

After Operation

After Operation Safety

General Safety
•
Shut off the engine, remove the key, and wait
for all movement to stop before you leave the
operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Clean grass and debris from the cutting units,
mufflers, and engine compartment to help prevent
fires. Clean up oil or fuel spills.
•
If the cutting units are in the transport position, use
the positive mechanical lock (if available) before
you leave the machine unattended.
•
Allow the engine to cool before storing the machine
in any enclosure.
•
Remove the key and shut off the fuel (if equipped)
before storing or hauling the machine.
•
Never store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or on other appliances.
•
Maintain and clean the seat belt(s) as necessary

Servicing the Cutting Unit

You can rotate the cutting unit from the T
position (A in Figure 37) to the S
Figure 37). Use the S
ERVICE
cutting unit blades or clean underneath the cutting
unit; refer to your cutting unit Operator's Manual.
position.
FF
position and
FF
RANSPORT
position (B in
ERVICE
position to maintain the
1. T position
RANSPORT
Rotating the Cutting Unit to the
S Position
ERVICE
Perform this procedure to rotate the cutting unit from
the T position to the S
RANSPORT
WARNING
If you leave the key in the switch, someone
could accidently start the engine and
seriously injure you or other bystanders.
Remove the key from the switch and do not
start the engine with the cutting unit in the
S position.
ERVICE
1. Park the machine a level surface.
43
Figure 37
2. S position
ERVICE
position.
ERVICE
g258473