Setup - Toro Groundsmaster 3300 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
7
8
9
10
11
12
Description
No parts required
Rear wheel
Small washer (2-wheel-drive only)
Large washer (2-wheel-drive only)
Bolt (5/8 x 1-1/4 inch) (2-wheel-drive
only)
Dust cap (2-wheel-drive only)
Lug nut (4-wheel-drive only)
Thread-locking compound
No parts required
Right lift arm
Left lift arm
Large pin
Bolt (3/8 x 2-3/4 inches)
Nut (3/8 inch)
Small pin
Sensor bracket
Carriage bolt
Bolt (3/8 x 1-1/4 inches)
Grease fitting
No parts required
Tie-down bracket
Bolt (3/8 x 3-1/4 inches)
Nut (3/8 inch)
Seat Kit (ordered separately; refer to
your authorized Toro distributor)
Steering wheel
Cover
Sound decal (Part 144-0512)
Bumper
Bolt (3/8 x 2-3/4 inches)
Bolt (3/8 x 3-1/4 inches)
Nut (3/8 inch)
No parts required
No parts required
Qty.
Remove the machine from the shipping
–
container (Models 31900, 31901, and
31907 only).
2
2
2
Install the rear tires (Models 31900,
2
31901, and 31907 only).
2
8
Remove the front tires (Models 31900,
–
31901, and 31907 only).
1
1
2
2
6
Install the lift-arm assembly (Models
31900, 31901, and 31907 only).
2
1
2
2
2
Install the front tires (Models 31900,
–
31901, and 31907 only)
1
Install the tie-down bracket (Models
2
31900, 31901, and 31907 only).
2
Install the seat (Models 31900, 31901,
1
and 31907 only).
1
Install the steering wheel (Models
31900, 31901, and 31907 only).
1
Install the sound decal (Models 31907
1
and 31909 only).
1
2
Install the bumper (Models 31900,
31901, and 31907 only).
4
6
Adjust the roll-bar position (Models
–
31900, 31901, and 31907 only).
Connecting the battery (Models 31900,
–
31901, and 31907 only).
11
Use