Huawei LUNA2000-100KTL-M1 User Manual page 58

LUNA2000-100KTL-M1 Smart Power Control System
User Manual
Connection Mode
After the DC or AC side of the Smart PCS is powered on, the app can connect to
the Smart PCS through the WLAN module.
● The USB-Adapter2000-C WLAN module is supported.
● The mobile phone operating system must be Android 5.0 or later.
● Huawei and Samsung phones are recommended.
Figure 6-2 WLAN module connection
(A) Smart PCS
● If the AC switch between the Smart PCS and the power grid is turned on, but
● If you change the grid code, some parameters may be restored to factory
● When the Smart PCS receives a reset, shutdown, or upgrade command, it may
● When the Smart PCS is powered on for the first time, ensure that the
● Only professionals are allowed to set the grid, protection, feature, and power
Issue 02 (2023-01-10)
NO TICE
NO TICE
the external switch on the DC side of the Smart PCS is turned off, some
parameters cannot be set. Turn on the external switch on the DC side, and then
reset the parameters.
defaults. After the grid code is changed, check whether any previously set
parameters are affected.
disconnect from the grid, affecting the energy yield.
parameters are set correctly by professional personnel. Incorrect parameter
settings may result in noncompliance with the local standards and affect the
normal operations of the device.
adjustment parameters of the Smart PCS. If the grid, protection, and feature
parameters are set incorrectly, the Smart PCS may disconnect from the grid. If
the power adjustment parameters are set incorrectly, the Smart PCS may not
connect to the power grid as required. In these cases, the energy yield will be
affected.
Copyright © Huawei Technologies Co., Ltd.
(B) WLAN module
6 Power-On Commissioning
(C) Mobile phone
52