Table of Contents
Advertisement
Sub Menu
1
Area Marker1, 2
Enable
H Position
V Position
Width (dot)
Height (dot)
Mask
Line
Line Width
Line Color
Line Brightness
There are two types of [Area Marker]: 1 and 2, which share the same settings. [Area Marker] is used
to check a specific area using a rectangular box.
On, Off
Switches the area marker On, Off.
0 to 3830
Sets the start position (x-coordinate) to draw the rectangle (in increments
of 2).
0 to 2150
Sets the start position (y-coordinate) to draw the rectangle (in increments
of 2).
10 to 3840
Sets the width of the rectangle (in increments of 2).
10 to 2160
Sets the height of the rectangle (in increments of 2).
Black
Switches the mask color (in the marker).
Half
Off
On, Off
When [Mask] [Black] or [Half]
Turns On/Off the outlines of the rectangular box.
Thick
When [Mask] [Off] or [Line] [On]
Normal
Sets the width of the area marker line.
Thin
White, Red, Green,
When [Mask] [Off] or [Line] [On]
Blue, Yellow, Cyan,
Sets the color of the area marker line.
Magenta, Gray
High, Low, Half
When [Mask] [Off] or [Line] [On]
Sets the brightness of the area marker line.
Setting Options (Factory default)
OSD Menu
43
Advertisement
Table of Contents
