Table of Contents
Advertisement
Sub Menu
Line Color
Line Brightness
1
Safety Zone Marker 1, 2
Enable
Aspect Ratio
Area Size
Rate (%)
Width (dot)
Height (dot)
White, Red, Green,
Sets the color of the aspect marker line.
Blue, Yellow, Cyan,
Magenta, Gray
High, Low, Half
Sets the brightness of the aspect marker line.
There are two types of [Safety Zone Marker]: 1 and 2, which share the same settings. A safety zone
marker is used to set the safe zone of the image (actual displayed area) to check the image.
On, Off
Switches the safety zone marker On, Off.
16:9, 15:9, 14:9, 13:9,
Sets the aspect ratio of the safety zone marker.
4:3, 2.39:1, 2.35:1,
1.896:1, 1.85:1, 1.66:1,
[Variable]: The aspect ratio can be entered as a numeric value (0.01:1
Variable
• When Variable is
• When [Area Size] is set to [Variable (dot)], you cannot select [Aspect Ratio].
selected
1.00:1 to 3.00:1
80%, 85%, 88%, 90%,
Sets the safety zone marker area size.
93%, 95%, Variable (%),
Variable (dot)
[Variable (%)]: The grayed out [Rate (%)] becomes active.
[Variable (dot)]: The grayed out [Width (dot)] and [Height (dot)] become
50 to 100
When [Area Size] [Variable (%)]
Move the slider to set the displayed marker area size without changing the
aspect ratio in 1 % increments.
20 to 3840
When [Area Size] [Variable (dot)]
Move the slider to set the area width in 2 dot increment.
20 to 2160
When [Area Size] [Variable (dot)]
Move the slider to set the area height in 2 dot increment.
Setting Options (Factory default)
increments). The grayed out slider becomes active and can be used
to set the aspect ratio.
active.
OSD Menu
41
Advertisement
Table of Contents
