Replacing Access Control Components; Replacing An Ic Card Reader - Huawei FusionModule1000A20 Maintenance Manual

FusionModule1000A20 Prefabricated All-in-One
Data Center
Maintenance Guide
Figure 6-15 Removing a camera
Step 2 Use a Phillips screwdriver to remove the screws that fasten the camera to its base.
Step 3 Remove the network cable and take out the camera.
Step 4 Install the new camera by following instructions in documents delivered with the
camera, tighten the screws to secure the camera to the base, and reconnect the
network cable in the original way.
Step 5 Adjust the angle of the camera to cover the monitored area by following
instructions in documents delivered with the camera.
Step 6 Configure the camera by referring to the management system initial configuration
table.
Step 7 Check that the new camera is working properly.
----End

6.3.6 Replacing Access Control Components

6.3.6.1 Replacing an IC Card Reader

Prerequisites
A spare IC card reader of the same model is available and functional.
Impact on the System
None
Preparations
Tools: Phillips screwdriver, protective gloves
Materials: access card, spare IC card reader
Skill requirement: ELV engineer
Issue 03 (2022-12-15)
NO TE
The original parameter settings can be used.
Copyright © Huawei Digital Power Technologies Co., Ltd.
6 Parts Replacement
91