GE ApexPro Service Manual page 52

modify Command
Other Commands
2-36
Equipment Overview: Service Utilities
Command
display<Space>ttx
display<Space>unitlist
The commands listed below permit modifications to the ApexPro application.
Command
modify<Space>unit ApexPro tower's unit name.
modify<Space>tower ApexPro tower's device name.
modify<Space>ip IP address used by the ApexPro application to talk to the
Unity Network.
modify<Space>rack IP address used by the ApexPro application to talk to the
telemetry system.
modify<Space>receiver Receiver/unit assignments for this ApexPro tower.
127(
See "ptsconfig Modify Receiver Command"
The table below lists other ApexPro software commands.
Command
admit Admits a patient on this ApexPro tower ("admit" shows usage).
discharge Discharges a patient on this ApexPro tower ("discharge" shows
usage).
dload Downloads rack software ("dload" shows usage).
resetrack Immediately (with no confirmation) resets all racks connected to
the tower.
blink: Blinks rack LED(s) according to:
„ „
patient entered patient name (UNIT|BED)
„ „
rack entered ApexPro tower IP address
„ „
receiver entered ApexPro tower IP address and receiver number
„ „
stop stop any blinking.
boot Reboots the PC ("DDMM" password required: confirmation is also
requested).
ApexPro Telemetry Server
2001989-178
Displays
Displays network-wide in-use TTX list (from the TTX
master list).
network-wide unit/receiver list (from the TTX master
list).
Modifies
on page 3-29.
Function
Revision C