GE ApexPro Service Manual page 156

6-22
Parts Lists, Drawings and Replacement: Disassembly/Assembly
11. Disconnect the alarm reset, and the chassis LED connectors from the
receptacles along the left edge of the SNMP connection board. Note the
position and orientation of the connectors for reassembly.
12. Using a phillips screwdriver, remove the 4 screws securing the SNMP card to
the chassis. Note the position and orientation of the connectors for reassembly.
13. Remove the SNMP connection board.
14. Reverse the steps in this procedure to install the SNMP boards.
&$87,21
EQUIPMENT DAMAGE — Use extra care to make sure the pins
are properly aligned before seating the SNMP extension board.
Bent/broken pins may result if the pins are misaligned.
15. If applicable, perform the
ApexPro Telemetry Server
2001989-178
Chassis
LED
Connector
Connector
"Electrical Safety Tests"
Alarm
Reset
022A
022A
on page 4-10.
Revision C